How to Solve The Current Instability of Main Machine of Dongguan Small Extruder 

        In the daily use of Dongguan extruder equipment, with the passage of time, some large and small faults are normal. In the daily operation of small extruder, the host current instability has become one of the common failures. The following is a detailed introduction to the causes and elimination methods of this failure:

        1. plastic extruder host current instability causes:

(1) Uneven feeding.

(2) Main motor bearing damage or poor lubrication.

(3) A certain section of the heater fails to heat.

(4) Screw adjustment pad is not correct, or the phase is not correct, element interference.

        2. plastic extruder host current instability treatment method:

(1) Check the feeder and troubleshoot.

(2) Overhaul the main motor and replace the bearing if necessary.

(3) Check whether each heater works normally and replace the heater if necessary.

(4) Check the adjusting pad and pull out the screw to check whether the screw interferes.